Wood N Kraft – Refinishing & Repair in West Michigan

What to Expect During the Hardwood Floor Refinishing Process

From the first visit to the final walkthrough, here's how a hardwood floor refinishing project runs — and what you'll need to do to get ready.

Refinishing & Repair in West Michigan: an edge sander smoothing a herringbone floor down to bare wood.

Refinishing brings a worn hardwood floor back without the cost or disruption of replacing it. It’s also a project that takes over a room for a while, so it helps to know what’s coming. Here’s how a typical job runs, in the same order we follow on every project.

Before any work starts

It begins with a consultation. We look at the floor, talk through what you want from it — color, sheen, how the room gets used — and recommend the best approach. You then get a clear, written estimate outlining the work and the cost before anything is scheduled.

Getting the room ready

Before work begins, we ask that you remove furniture and personal belongings from the areas being refinished. Rugs, curtains that reach the floor, and anything on the walls near floor level are worth moving too. Sanding is dusty work, so it also helps to plan which rooms and doorways you’ll need access to while the job is underway.

Repairs come first

Anything that needs fixing is handled before the floor is sanded: damaged or split boards are cut out and replaced, gaps are addressed, and loose or squeaking boards are secured. Doing this first means the repairs get sanded and finished along with the rest of the floor, so they blend in.

Sanding to bare wood

The floor is then sanded to remove the old finish and any surface wear, taking it back to clean, bare wood. Flat, even sanding is what separates a floor that looks properly finished from one that only looks sanded, which is why this stage gets the most care.

Stain and finish

If you’ve chosen a stain, it goes on next. Then comes the protective finish, applied in coats, with drying time between each one. We work with a range of finishes — hard wax oils, natural penetrating oils, and water- and oil-based polyurethanes — and the right one depends on the look you’re after and how much traffic the room takes.

Drying and getting your room back

Once the last coat is on, the floor needs time to cure before it’s ready for furniture and rugs again. You can usually walk on it carefully well before that point. We’ll give you the day-by-day schedule with your estimate so you can plan around it.

The final walkthrough

When the work is done, we walk the finished floor with you to make sure everything meets your expectations. After that, looking after the new finish is what keeps it looking good for years.

Ready to get started?

Not sure your floor is due? Our guide to the 5 signs your hardwood needs refinishing or repair is a good place to start. When you’re ready, schedule a consultation and we’ll take a look.

Ready to Get Started?

Reach out today and let's talk about your floors.